6 ms·
Genuinely curious about the fuse indicate you mention. On one hand it seems very useful! On the other hand, wouldn't this: a) pass a small amount of current in
by SpikedCola 6y ago
Genuinely curious about the fuse indicate you mention. On one hand it seems very useful! On the other hand, wouldn't this:
a) pass a small amount of current in what would otherwise be a 'fault' condition? a few mA or so to light the globe/led
b) depend on the load you have? a resistive load would allow the few mA to pass, but what about a regular led lightbulb (with a driver inside)?
- hilbert42 6y agoThe indicator in any fuse indicate system draws minuscule current compared with the normal running current of the device (one hundredth the normal operating current or less would not be uncommon). Essentially, if say the power supply capacitors short-circuit and they blow the fuse then the residual current through the indicator and its current limiting resistor is so low that no additional damage will result. Incidentally, the current limiting resistor and indicator are power rated for short circuit conditions (i.e.: I^2R rating of the indicator and its limiting resistor are such as to maintain the indicator working indefinitely). extrapickles is correct, and he's right about spring-loaded fuses in old telco gear. Moreover, there are many other systems for indicating faults depending on the type of fault. The issue here is that they don't indicate a fault until one actually occurs—by default they're 'off' until a fault appears.
- extrapickles 6y agoIn older telco gear they used fuses that were basically a spring held down with fuse wire, that when blown, made contact with the fault circuit. They effectively where a fuse activated switch. When doing the led across the fuse trick, you need to make sure that the few mA passed is not harmful.