3 ms·
It would be fun to try this with a 96kHz audio card (audiophiles, this is your moment!) and trying this with a large band like 20kHz-40kHz (you would need an ul
by raverbashing 6y ago
It would be fun to try this with a 96kHz audio card (audiophiles, this is your moment!) and trying this with a large band like 20kHz-40kHz (you would need an ultrasound transducer and amplifier, of course)
You could probably get, I dunno 200kbps?
- namibj 6y agoActually, there are 192 kHz sound cards. As an example, I just picked the first microphone from mouser who's datasheet includes ultrasonic spectral response. In this case it's a roughly 321 mm package with the acoustic port in the middle of the annular ground pad, likely requiring a hole/via below. https://www.mouser.de/ProductDetail/PUI-Audio/AMM-2738-B-R?qs=zhx2xqPtQQyuc2nfUlDL7A%3D%3D https://www.mouser.de/ProductDetail/PUI-Audio/AMM-2738-B-R?q... Here's the datasheet: https://www.mouser.de/datasheet/2/334/AMM-2738-B-R-1761381.pdf https://www.mouser.de/datasheet/2/334/AMM-2738-B-R-1761381.p... It is not nearly as flat above 8 kHz as below, but it's between -35 and -28 dB (V/Pa) in the 20 to 80 kHz range. Nominal sensitivity is -38(+-1) dB (V/Pa) between 20 Hz and 8 kHz. What this means, is that a 24bit 192 kHz ADC with relatively flat response and no extra pre-amp should recover most of the SNR (specified at 64 dB(A) SNR 1kHz 94 dB @ 50cm). I expect it to work well with a normal TRRS "smartphone" jack, just connecting the output via a decoupling capacitor to the sleeve and using the phantom power. The TRRS compatibility guess is based on the numbers given in this comment: https://www.epanorama.net/blog/2014/09/15/android-device-external-mic-wiring/comment-page-1/#comment-1460917 https://www.epanorama.net/blog/2014/09/15/android-device-ext... Assuming one could exploit 60 dB SNR over the 60 kHz wide band, the Shannon–Hartley theorem says there'd be a ceiling of 1.2 Mbit/s. Spectral efficiency would be 20 bit/s / Hz, and for the SNR range above ~10 dB, (dB SNR)/(bit/s /Hz) equals 3. Your 20 kHz to 40 kHz band would actually give a nice 400 kbit/s with 60 dB SNR, or 200 kbit/s with 30 dB SNR. The ultrasonic speaker for these frequencies can be just a normal piezoelectric horn with either a crude class-A audio amplifier who's low-pass filter was suitably adjusted/removed, or a more efficient class-D device that can handle the relatively high frequencies. Considering the rather high lower end of the required band, a simple digitally-fed bipolar current source with pulse-density modulation fed to the tweeter should be sufficient.