4 ms·
The lossy compression on phone calls might prevent fax from working. Also, I don't know if you can route call audio from anywhere other than the microphone.
by wmf 7y ago
The lossy compression on phone calls might prevent fax from working. Also, I don't know if you can route call audio from anywhere other than the microphone.
- mceachen 7y agoHQ audio quality (over 4G) is markedly better than land lines, and the fax protocol has had error correction since digital formats were adopted in the 60s and 70s. https://en.m.wikipedia.org/wiki/Fax https://en.m.wikipedia.org/wiki/Fax My Palm Pilot (with a CDPD backpack) and candybar 2G Nokia could both send FAXes. I suspect there's no demand.
- mappu 7y agoAs a reference point, if you have a cellphone plan with minutes but no data plan, it's not really feasible to dial a 56k-modem endpoint, as it makes use of frequencies that are chopped by the voice codec.
- mattrp 7y agoFax has an ip protocol called t.38 however it is inconsistently implemented. Most services still rely on g.711 - essentially uncompressed voice - for transmission of fax tones. However there is no guarantee the end to end call will be g.711 even if specified during call setup. There is an app called eFax - unfortunately the service is not free but I as a subscriber routinely fax over the phone when it’s the only way to communicate (like with a doc office).
- tjohns 7y agoWhile G.711 is uncompressed (it’s the same codec used within the PTSN backhauls), it’s still not great for fax because the fax protocol doesn’t tolerate the jitter introduced by VoIP. (Reliable latency is the one big benefit to switched networks like the PTSN.) As I understand it (and I could be wrong), T.38 solves this by emulating an independent fax modem on each side of the analog connection, and only sending the image data over IP as opposed to sending audio.
- mattrp 7y agoYou’re right g.711 is not ideal either. Jitter is a killer. T.38 is a solution when it’s supported on both sides and it is often not. The best solution is email but apparently every title office and pediatrician in the land cannot be bothered! ;) Although thankfully many have moved on.
- Retric 7y agoThe parent’s post is correct. While the perceived quality is much higher, modern cellphones use a lossy format optimized for voice communication. From an engineering perspective, having a billion cellphones faithfully transmitting info on frequencies humans can’t hear is simply wasteful. https://en.wikipedia.org/wiki/Adaptive_Multi-Rate_audio_codec https://en.wikipedia.org/wiki/Adaptive_Multi-Rate_audio_code... “AMR was adopted as the standard speech codec by 3GPP in October 1999 and is now widely used in GSM[5] and UMTS.”
- shawnz 7y agoFax uses frequencies that humans can hear though (up to 4KHz)
- Retric 7y agoSampling frequency 8 kHz/13-bit (160 samples for 20 ms frames), filtered to 200–3400 Hz. The AMR codec uses eight source codecs with bit-rates of 12.2, 10.2, 7.95, 7.40, 6.70, 5.90, 5.15 and 4.75 kbit/s. Fax machines on the other hand go up to 33kbit/s. PS: People can produce and hear frequencies well above 3400 Hz, but for phone calls people just don’t notice clipping those frequencies. If anything it helps by removing some background sounds.
- deleted 7y ago[deleted]
- shawnz 7y agoRight, so it must be the bit depth which is the problem, not the frequencies that can be reproduced
- ken 7y ago> HQ audio quality (over 4G) is markedly better than land lines This is one of those facts that, no matter how many times I hear it or what proof is offered, I find it impossible to believe.
- rsynnott 7y ago... Wait, why? Standard landlines are 300hz to 3.4khz; pretty low-fi. They should not be particularly hard to beat. VoLTE certainly sounds better than them. Your network or device may still be using the 90s cellular voice standard, tho.
- closeparen 7y agoWhat's the latency story for VoLTE? Hard to beat analog circuit switching.