4 ms·
My first technology job was for a computer store that did the same thing to get an old hard drive to spin up so they could copy the files off to a new drive.
by bdcravens 7y ago
My first technology job was for a computer store that did the same thing to get an old hard drive to spin up so they could copy the files off to a new drive.
- jacquesm 7y agoI highly doubt that's the same mechanism though, this has to do with the carrier of the tape getting stuck, something harddrives do not have a problem with. Typically with old harddrives that haven't run for years it is enough to put a drop of oil on the spindle bearing and then to spin it up manually before engaging the motor (which may otherwise burn out trying to unstick the bearing).
- defterGoose 7y agoIt probably works because heating whatever lubricant remains in the spindle bearing lowers its viscosity enough to allow the motor to spin it up, which will in turn keep the lube warm enough to allow it to form a film. Not the same mechanism, surely, but a similar one.
- kitotik 7y agoHuh. I’ve only heard of the opposite approach - throwing a dead drive in the freezer before a last ditch attempt at data recovery.
- bdcravens 7y agoMy understanding is that the lubrication in the drive had hardened and the heat is an emergency solution for that.
- walrus01 7y agoOld hard drives with stuck spindle motors can be temporarily resurrected, with some risk and low degree of success, by freezing them for 12 hours and then plugging them quickly into a test bench computer to attempt data extraction.