3 ms·
the overhead lamps are not what you want, you want the bulb for the UV sterilizer that is normally used for UVirradiation of water circulating through a manifol
by rolph 7y ago
the overhead lamps are not what you want, you want the bulb for the UV sterilizer that is normally used for UVirradiation of water circulating through a manifold.
you dont want to use this as normal illumination, it is damaging to the eyes.
there is a system where microbiological labs are under constant intense illumination with UV while they are unoccupied. you would be doing something similar i suppose?
have look here as an example of what you would need to do a proper job:
https://www.light-sources.com/solutions/germicidal-uvc-lamps/uv-light-applications/uv-light-sterilization/ https://www.light-sources.com/solutions/germicidal-uvc-lamps...
https://www.light-sources.com/solutions/germicidal-uvc-lamps/uv-germicidal-lamps/low-pressure-mercury-lamps/high-output-quartz/ https://www.light-sources.com/solutions/germicidal-uvc-lamps...
- sgroppino 7y agoI was thinking something like this https://www.ebay.co.uk/itm/283782783926 https://www.ebay.co.uk/itm/283782783926 or even this https://www.amazon.co.uk/gp/product/B00J3EUJPA https://www.amazon.co.uk/gp/product/B00J3EUJPA to build some kind of wand to sterilize packages or clothes as I walk through the door. Just checked your links - I'm surprised the output is super low: 48W only yields 120uW/cm2. Does it mean a 12W UVC lamp would yield ~30uW/cm2? In terms of virus sterilization, would I need to expose the surface to a 12W for 80sec to get the 2.4mWsec/cm2?
- rolph 7y agoahh ok its not like a light sabre :) its like a half life thing, the energy from the UV radiation makes the molecules of the virus shimmy and shake until it breaks, and this is time dependent so for a given |dosage| of UV you need wattage over time at distance from the source. it might be better to hang the garment in a closet or enclosure and expose it for a period of time. in particular, the cuffs, and the upper chest lapel area, and the hip/pocket area these are typical hotspots.
- sgroppino 7y agojust pictured myself with a Darth Vader mask and a UVC portable sabre to kill covid-19... re-reading those specs "Measurements were performed on a high-frequency, current limited electronic ballast and represent average values at 1 meter" - this means the output could be considerable higher at a few inches and it'll take only a few seconds to sterilize small garments (and mobile phones). It could work.
- rolph 7y agoyou just have to be carefull about repeated exposure of skin and eyes. light energy dissipates as a square function of distance the general idea is quarter the energy for 1 foot distance increase a quarter of that again when you get to 4 feet away... maybe this is more concise: https://en.wikipedia.org/wiki/Inverse-square_law https://en.wikipedia.org/wiki/Inverse-square_law
- rolph 7y agothat sounds right the distance is the variable to get here its inverse square dependent. usually flux is at 1 foot distance to keep the measurements in a standard framework. have a look here re inverse square: https://en.wikipedia.org/wiki/Inverse-square_law https://en.wikipedia.org/wiki/Inverse-square_law