3 ms·
> Why does this still have 10 pins? 2 pins would be plenty. No, modern desktop can easily use up to 30A constant load. No way to provide so much over 1mm wires
by baybal2 7y ago
> Why does this still have 10 pins? 2 pins would be plenty.
No, modern desktop can easily use up to 30A constant load. No way to provide so much over 1mm wires at 12V
- loeg 7y ago10-gauge is rated for 30A, though that's 3.6mm.
- hinkley 7y agoAnd it looks like 2mm and rated for 15A, and 1mm for 10A. (I thought DC current used the volume of the wire and AC the surface area, so I'm a bit surprised that wire ratings don't distinguish AC and DC. Though I suppose heat dissipation is determined by the surface area so perhaps that makes sense.)
- Gibbon1 7y agoSkin effect becomes an issue for high frequencies. But is nil at low frequencies. I used an calculator and got 8416.7115um for 60hz. Which is 8.4mm. So not an issue for power wiring under 0000.
- mrb 7y agoActually the limiting factor is the amperage rating of the molex terminals ("pins") that make the physical contact. I have expertise in this area back from the days of Bitcoin GPU mining where I built custom cables that I crimped myself after buying the molex housings, molex terminals, and wire. Each individual terminal, formally called a Molex mini-fit junior terminal, is rated either 7.0A (typical for those with 2 contact springs) or 9.0A or 13.0A (for those with 4 contact springs.) As you can imagine, most cheap PSUs and wire harnesses are made of terminals with 2 contact springs, so the three 12V wires on the ATX12VO spec allow a max of 3×7.0A = 21.0A or 252 watts. As to voltage drop caused by resistance in the wire, it will be sufficiently small with 16AWG wire which will easily carry 7A over the short distances in a PC case.
- mrb 7y agoJust looked at the ATX12VO spec and it mentions the max current per pin, page 12: "the guideline to follow is 6-8 Amps per pin"