3 ms·
> Ideally you would use a turntable to rotate the cylinder while welding the sections together with a sub-arc machine. https://www.youtube.com/watch?v=j-hfExEm
by gpm 7y ago
> Ideally you would use a turntable to rotate the cylinder while welding the sections together with a sub-arc machine. https://www.youtube.com/watch?v=j-hfExEmGsE https://www.youtube.com/watch?v=j-hfExEmGsE
Uh, at least in the video that steel is pretty thick. Starships skin is slightly less than 4mm thick... while in that video they have a 2cm deep groove, would the same technique actually work?
For what it's worth, ULA stainless steel (<1mm thickness) upper stages are resistance welded instead https://www.youtube.com/watch?v=o0fG_lnVhHw&t=41m10s https://www.youtube.com/watch?v=o0fG_lnVhHw&t=41m10s
That said, I think a lot of the decisions right now are based on "what can we quickly experiment with" not "what is a good long term plan". Building a 9m turntable (diameter of the rocket) would take a long time.
- frankharv 7y agoI agree a 9m turntable would take some time to make. But once made you could crank these vessels out very fast. 4mm skin sounds OK and I am sure there are some structural supports inside to keep it from collapsing. I am not a weld engineer so I cannot say if Sub-Arc would be the best technique. I know that ships skins are being built with it.
- erikpukinskis 7y agoYou’re talking about production engineering. You don’t really do that until your design starts to be nailed down. It’s not.