5 ms·
Hmm are we having another "AMD motherboards are crap" moment? Or is it simply that delivering 200+W at load through a CPU socket can't be reliably done at cons
by nottorp 7y ago
Hmm are we having another "AMD motherboards are crap" moment?
Or is it simply that delivering 200+W at load through a CPU socket can't be reliably done at consumer prices?
Anyone has had this problem with less high end CPUs? Something at 95-65 W?
- close04 7y agoAnything with sTRX4 socket should be able to handle at least between 250W and 280W. But it's not out of the question that many motherboard designs draw a lot from AM4 boards which have much lower requirements, to keep costs down. This may be the result. The "CPU defective by design" in the title might be a bit misguided since the suggested workarounds do not address a CPU issue but a motherboard one.
- franzb 7y agoI agree (my fault, sorry) but the fact is that several people are encountering the exact same issue with a variety of motherboards. So either all those motherboards are "defective" or the problem is more complex than it looks. My motherboard is the highest end consumer motherboard GIGABYTE has ever built (as far as I know), and I wouldn't say that they tried to keep costs down (it's listed at $849 on PartPicker, and it was introduced at $999) and the power delivery stage is insane. Here's BuildZoid's _in-depth_ review and analysis of its VRM: https://www.youtube.com/watch?v=HMUWzDSAS9c https://www.youtube.com/watch?v=HMUWzDSAS9c
- ComputerGuru 7y agoI learned a long time ago to never get the most expensive motherboard (ASUS Republic of Gamers many years back): they're not as heavily tested as the cheaper ones. They are only ostensibly better; in practice, the mid-level "workstation-class" motherboards that feature similar capabilities but missing fancier options are put through the works and far more thoroughly tested and debugged. Just look at the BIOS changelogs and even the hardware revisions for high-but-not-flagship-high motherboards as compared to the flagship models. When you buy the top-of-the-line, you're on your own. I now literally go out of my way not to get the flagship motherboard models, even if it means holding off on a purchase until a lower-spec'd model comes out, and have never regretted it since. (I also will never again buy Gigabyte motherboards, either.)
- hermitdev 7y agoI have an ASUS ROG mobo. I can't do a soft reset of the computer with RAID enabled. For some reason on restart, it fails to recognize my SSD (I have an SSD as my boot drive and 3 HDD in a RAID array for data). Without fail, I always get "No boot drive detected". I have to do a hard power cycle every time. Annoying when Windows updates require multiple restarts sometimes...
- close04 7y agoI see Gigabyte being singled out more than the rest so I wonder if this is another "fake phases" debacle as it happened to them in the past. They advertise the board now as having "real phases". It's not out of the question that they took a shortcut elsewhere in order to meet some efficiency expectations or anything else like this. Just because it's high end doesn't mean they won't cut corners or fail to test properly. My ROG motherboard was (at the time) the most expensive motherboard for the socket. Yet it behaved overall worse than many mid/low-end motherboards I owned, an experience shared with other owners of the same board. Even if this is a problem with the CPU that is mitigated by changing parameters of the motherboard it should have been caught during the motherboard design and testing. I can't imagine Gigabyte's engineers noticing this stuff and saying "just ship it like that, nobody will notice". So the best interpretation I can have is that they missed it during testing (the worst is that the marketing department said "we have to put it out there fast, all else be damned", and all else was damned).
- clarry 7y ago> Just because it's high end doesn't mean they won't cut corners or fail to test properly. My ROG motherboard was (at the time) the most expensive motherboard for the socket. High end in consumer stuff, and especially anything gaming related, is basically scam.. look mah, 16000 dpi! And blingy leds! (But no engineering) Sure they might drop an over-specced part somewhere in it but it's just marketing when the rest of the product is crap and still has no proper engineering behind it. It's incredibly frustrating. I think there was a time when you could generally assume that expensive = high end = actually good, but now it's just a cheap thing with crazy markup and a premium part (but nowhere near premium enough to justify the markup) or two somewhere (where it probably doesn't matter much anyway) along with other gimmicks. Now it's just expensive = expensive, good or maybe not.
- speeder 7y agoI have a AMD GPU, a 380X... and to be honest I am just sure AMD power management is crap in general. 380X in particular has bigger demand than 380, but AMD didn't bother raising power limit, causing some weird issues (some games for example get unstable unless I use some overclocking app to reduce voltage and raise power limit... mind you, the normal 380 people already used it with maximum power limit by default, because it was already too low...). Then we get the R480 melting cables for the same reason... and so on.
- nottorp 7y agoHmm whatever is melting cables is drawing more power than the cables are specced for. I doubt increasing the power limit will help with that...
- speeder 7y agoYou are correct. But what I meant is that the source of the problem was the same. In this case, AMD wanted to keep using 6pin cable despite it not being approprite, on the 380 it just slowed it down. On 380X, it is unstable, it still don't draw enough to melt things, but you need hackery to make the GPU useable The 480 they outright made a GPU that used more power than the cables specs would allow, and insisted in using the same power delivery design the 380 had... Their "fix" to the issue was make patches that would just make the GPU run slow, and make it misbehave like the 380X does.
- jotm 7y agoWow, that's ridiculous...
- paulmd 7y ago> Then we get the R480 melting cables for the same reason... and so on. RX480 wasn't melting cables, it was melting motherboards. The stock VBIOS was pulling more power than the PCIe spec allowed you to pull from the slot. It was pulling over 100W, vs the 75W spec, not massive but probably enough to push some older/weaker boards over the edge (most of which were just ready to fail anyway and were going to fail from a solid 75W draw too). https://www.tweaktown.com/news/52871/amds-radeon-rx-480-drawing-much-power-over-pcie-slot/index.html https://www.tweaktown.com/news/52871/amds-radeon-rx-480-draw... It's pretty hard to melt a cable. You can overdraw the connectors by roughly twice their rated power safely, and the cables will do more than that as long as you're not using splitters or some other hack. The 295x2 pulled almost 500W through a pair of 8-pins and the slot (nominally that's 375W rated) while overclocking.
- jolan 7y agoI see similar behavior with a 105W 3950X when running prime95. I haven't experienced instability otherwise over the 2 months I've had this build running. Google's stressapptest runs fine for long durations, building a kernel with make -j32 succeeds (and can boot it), every parallelized archiver like 7z,pbzip2,pigz,xz is ok, and even gaming on a Windows VM using 8c/16t + GPU passthrough works well. This is my first Ryzen system so I chalked it up to a possible carry over of DDR4 issues from earlier generations. I didn't investigate further since the 3950x had just been released and I couldn't find any other reports of prime95-only instability until now. And just to reiterate, it is perfectly stable otherwise. Heavy AVX2 workload breaking things fits better so will have to try to collect more data.
- d1zzy 7y agoI'm still eyeing the 3950x as my next upgrade so I hope this gets resolved through a BIOS update or something. What motherboard are you using for it? (I'm assuming stock settings, no overclock or PBO, AMD doesn't consider PBO to be stock)
- jolan 7y agoI picked the ASRock X570 Taichi since I needed 3 PCIe slots and it was on sale for ~$260. Very happy with it and yeah I'm not overclocking or using any of the quasi-overclock settings either.
- kllrnohj 7y ago> Or is it simply that delivering 200+W at load through a CPU socket can't be reliably done at consumer prices? It could be that the spike is the problem not the end load. The scenario in play here is going from entirely idle to maximum load in an instant. So the CPU is going to shoot straight from ~20-30w usage to 280w (or even higher if the power management is a bit sluggish at reducing the clocks). That's a pretty drastic swing if anything isn't entirely up to spec, assuming the spec even handles this properly. In theory the 3970X could even spike all the way up to 430w. The individual cores top out at 13.5w, so if they all end up running at single-core turbo frequencies even for a split second that's going to be brutal. > Anyone has had this problem with less high end CPUs? Something at 95-65 W? My 3700X in an old X370 board has been flawless. As has many others, Ryzen 5/7/9 are _widely_ recommended and have been for a while. Any systemic issues in the "regular" consumer end would have cropped up by now.
- daneel_w 7y agohttps://news.ycombinator.com/item?id=22385821 https://news.ycombinator.com/item?id=22385821