2 ms·
This is a great picture, if you're a structural engineer. If you look at the body panels aft of the landing gear, you see wrinkles in the skin, from lower left
by bediger4000 7y ago
This is a great picture, if you're a structural engineer. If you look at the body panels aft of the landing gear, you see wrinkles in the skin, from lower left to upper right. Under the wing, you can see wrinkles from lower right to upper left. That means the skin has buckled in shear. This is known in the airplane trade as "diagonal tension". If you are careful, you can save a lot of weight by making the web of a deepish beam so thin that it buckles under limit load. You have to put in compression members to keep the flanges of the beam from collapsing vertically. In the case of the Rotodyne's body, that would probably be the periodic frames or rings.
I believe this technique was first used on the DC-3 wing spar.
Anyway, this means that the helicopter-rotor is pulling the Rotodyne up, causing the body to sag down on both sides of the wing. Either the Rotodyne is heavily loaded (crash-test dummies or something) or it's accelerating vertically. The depth of wrinkles would make me wonder if they skin is too thin, or ask if this was some kind of limit load flight test.
One of the other pictures in this article's slideshow is of the Rotodyne's interior, showing an alternative technique of lightening a beam's web: putting flanged holes in the web of the body frames. Sometimes you can't do thin webs for other reasons, maybe secondary loads like wiring or control surface cabling. You just cut holes and use some kind of ram to draw out flanges on the side of them.