4 ms·
I've achieved good results with just a laser printer. (Print mirror image onto glossy magazine paper, transfer toner to copper with clothing iron, wash paper a
by kazinator 7y ago
I've achieved good results with just a laser printer.
(Print mirror image onto glossy magazine paper, transfer toner to copper with clothing iron, wash paper away with water, etch, drill.)
https://i.imgur.com/JtMQemK.jpg https://i.imgur.com/JtMQemK.jpg
https://i.imgur.com/2olwewD.png https://i.imgur.com/2olwewD.png
I have used markers for touching up toner-transfer boards (not that one). I found that markers do not resist the etching solution as well as toner. Toner provides a higher build of plastic resin material on the surface than the trail left by a marker. (Perhaps doing multiple coats with the marker could build it up.)
I would also highly recommend doing "copper pours" as I did with the above board. Etch away as little copper as possible. The etch will be efficient and fast.
The circuit board in my above images was etched inside a tiny container, in minutes! In fact, the "etching tank" I used was a plastic bottle cap from a 1.9 liter V-8 juice.
If you etch away most of the copper and insist on getting those large, etched areas very clean, that may take so much etching that it will eat into the traces that you want to keep, leaving them in rough shape, and maybe even nonworking.
The resist only protects the copper from the top. The sides of every trace are exposed. Leave it in the solution long enough and the etchant will work its way under the resist and etch them away.
Of course, copper pours require large black areas, which probably doesn't translate to good economics if you're using markers. A mixed approach might be possible: do smaller copper pours in the the nooks and corners around the traces and pads, and cover large areas with rectangular pieces of electrical tape.
- StavrosK 7y agoYou're basically spot on, I had all these problems that you mention. I didn't think of adding planes (I actually had them but removed them) because I didn't want the printer to spend an eternity drawing, but after you mentioned it, it makes sense that it's definitely worth it. That's what I'll be doing from now on, thank you!
- Zardoz84 7y agoMy father (and my self did a few) made a lot of prototype PCB with the toner technique. A trick that I learned from him, was giving a coat of tin alloy to fix any micro cut made by defects on the copper or the toner transfer.