4 ms·
1/8" plywood is about 70 micron tolerances, once you account for kerf. This is dependent upon not getting super fine tiny thin pieces that tend to warp. 1/4"
by mlyle 7y ago
1/8" plywood is about 70 micron tolerances, once you account for kerf. This is dependent upon not getting super fine tiny thin pieces that tend to warp.
1/4" plywood-- there's a whole lot of taper and edges aren't quite square. Multipass helps a little bit. Probably about half a millimeter of taper? For most things it just does not matter.