4 ms·
I'm not sure why one would ever consider mechanical properties of MDF when one could cut plywood, etc. The appeal of a laser cutter is you can cut things with
by mlyle 7y ago
I'm not sure why one would ever consider mechanical properties of MDF when one could cut plywood, etc.
The appeal of a laser cutter is you can cut things with no hold-down, engrave in the same pass, and get nice finished edges on acrylic or wood, including sharp corners and very small intricate details.
I have a milling machine, a plasma cutter, a CO2 laser, and 3D printers (and some other stuff). The laser cutter can't be used for everything, but for the stuff it can do I prefer it over any other tool. It's just easy and good.
- kragen 7y agoMDF laser-cuts a lot more predictably than plywood, and it's cheaper. I agree that laser cutters are super awesome. I wouldn't want to try to cut plywood or acrylic with a plasma cutter!
- justinclift 7y ago> I wouldn't want to try to cut plywood or acrylic with a plasma cutter! In theory (!) plasma cutters require the material being cut to be conductive.
- kragen 7y agoYeah, I've seen people trying tricks with sheet metal on top, but...
- mlyle 7y agoFiberboard certainly looks prettier, but I cut plywood all day long.
- kragen 7y agoWhat kind of tolerances do you get on your plywood cuts? Lasersaur is claiming they get down to 30μm on some materials. I'd think plywood would be more like 200μm, from what I've read, but I don't have any real experiences.
- mlyle 7y ago1/8" plywood is about 70 micron tolerances, once you account for kerf. This is dependent upon not getting super fine tiny thin pieces that tend to warp. 1/4" plywood-- there's a whole lot of taper and edges aren't quite square. Multipass helps a little bit. Probably about half a millimeter of taper? For most things it just does not matter.
- mlyle 7y agoJust one more note: my default construction material at this point for many things is sandwiches of 3D printed nylon innards with sheets of plywood or acrylic on the outside, all screwed together with M3 or M4 screws. It is stronk and fast to fabricate.
- kragen 7y agoThank you for sharing your experience!