2 ms·
While a pain, it isn't impossible. There will be an FCC ID that it has (due to transmitting receiving). Based on that device, you at least know what to look for
by kop316 7y ago
While a pain, it isn't impossible. There will be an FCC ID that it has (due to transmitting receiving). Based on that device, you at least know what to look for (a PCI card? An entire board? an Antenna?).
Since FCC testing is expensive, I would not doubt that many manufacturers just make one card to install into multiple cars (to lower the FCC testing cost). That would be the best case, as all you need to do is find and remove that card.
- _sbrk 7y agoInstead of doing that, I'd simulate "network loss" by substituting a 50 ohm dummy load for the output antenna. This assumes that it is a connector, not soldered right to the board. This way, there is no "fault" other than not being in a cellular-coverage area.
- kop316 7y agoThat's a good way too. Didn't think of that.