4 ms·
It honestly depends on where in the fab. One of the most dangerous things from a chemical perspective would be copper in the non-copper part of the factory. If
by bob1029 7y ago
It honestly depends on where in the fab. One of the most dangerous things from a chemical perspective would be copper in the non-copper part of the factory. If you set off something jacketed with copper right in the middle of the photolithography tool area, it would probably be game over for quite some time.
- hinkley 7y agoGiven we're in a hypothetical about 'how would you scuttle your own fab', and that I'm verbalizing the implicit "without hurting any employees", I'd guess that one or several team leads in charge of either automation design or maintenance could think of a dozen nightmare scenarios or even personal anecdotes of proverbial wires getting crossed and causing mayhem. If the solvent got into this line, or the effluent into this one, or the wrong voltage here, or the part installed backward here (because in The Expanse they don't have keyed sockets to prevent an employee from installing high current equipment backward, apparently... but I digress). We tend to be limited in our creativity, though. You mentioned a pretty violent way to distribute copper, isn't powdered copper a common ingredient in fireworks? You just need to get the copper airborne, unattended (copper poisoning I hear is pretty awful), not make a big boom. You would have absolutely no cause to have that material anywhere near let alone inside of a fab. But if a hostile takeover at gunpoint is actually a scenario you're concerned about instead of a bunch of randos bullshitting on the Internet? Wouldn't be hard to prepare some boxes and a laminated instruction sheet to put in a safe somewhere. In Case of Armed Invasion, Read Instructions.