6 ms·

Start with an Arduino and the Adafruit tutorials. Very gentle learning curve. https://learn.adafruit.com/category/learn-arduino https://learn.adafruit.com/categ

Start with an Arduino and the Adafruit tutorials. Very gentle learning curve. https://learn.adafruit.com/category/learn-arduino https://learn.adafruit.com/category/learn-arduino From there, can decide where your interests might be. To continue with Arduino hardware but without the IDE, I'd recommend _AVR Programming_ https://www.oreilly.com/library/view/make-avr-programming/9781449356484/ https://www.oreilly.com/library/view/make-avr-programming/97... For other low level programming, Atmel's AVR Studio and their dev boards are incredibley newcomer friendly. Their source level debugger (with the debug coprocessor) is a miracle. If you'd like to get into "big iron", Embedded Linux is amazing. Raspberry Pi is a great start (lots of GPIOS programmable from userspace). To get into embedded linux kernel programming, start with a loadable module on the Ras-Pi. Also, build/load your own Ras-Pi kernel. Other folks suggested the ESP8266 which is also great fun to use. Edit: Learn C. Lots and lots of C. Embedded dev is almost all C. A teeny bit of ASM, sometimes C++. But almost all of it will be in C.

daxaxelrod 7y ago
Very helpful, thank you!
andoma 7y ago
Can recommend https://buildroot.org/ https://buildroot.org/ for building complete Linux system images. Been using it on multiple embedded projects, both personal and professional. Somewhat related, I've also used buildroot in both AWS and GCP to run workloads from read-only system images. Quite liberating in my opinion. No ssh, no ansible, etc. Build the image, launch it and off it goes. GCE even allows you to use the same boot disk, if mounted read-only, for multiple instances, perfect for these type of images.
PascLeRasc 7y ago
I can second this as well, Arduinos have a bad rep for being too beginner-focused but AVR is a super solid platform and you can do a ton with them. I'd pick Arduino over RasPi for a starter project anytime.

daxaxelrod 7y ago

Very helpful, thank you!

andoma 7y ago

Can recommend https://buildroot.org/ https://buildroot.org/ for building complete Linux system images. Been using it on multiple embedded projects, both personal and professional. Somewhat related, I've also used buildroot in both AWS and GCP to run workloads from read-only system images. Quite liberating in my opinion. No ssh, no ansible, etc. Build the image, launch it and off it goes. GCE even allows you to use the same boot disk, if mounted read-only, for multiple instances, perfect for these type of images.

PascLeRasc 7y ago

I can second this as well, Arduinos have a bad rep for being too beginner-focused but AVR is a super solid platform and you can do a ton with them. I'd pick Arduino over RasPi for a starter project anytime.