3 ms·
The closest standard value for that resistor would be a 3k3, if I'm not mistaken... In the software industry we have a similar problem; alot of people can foll
by userbinator 7y ago
The closest standard value for that resistor would be a 3k3, if I'm not mistaken...
In the software industry we have a similar problem; alot of people can follow instructions on how to glue together lots of libraries and frameworks, but have no idea how to go beyond that --- or understanding of how computers work in general --- much less debug it when something goes wrong. There's a classic article about this:
https://blog.codinghorror.com/why-cant-programmers-program/ https://blog.codinghorror.com/why-cant-programmers-program/
- mlyle 7y agoYah, but IMO 1mA is on the "low end" of lit, so you want to round down the resistor value to get a little more current. Pick 2k7 instead. Most small LEDs will tolerate per datasheet 20mA; 4mA is "well-lit". A little less than 1mA is going to be pretty anemic looking on lots of LEDs. So I'd be more inclined to put down 470 to 1k5.
- Sanzig 7y agoIf it's just a bare LED on a board (ie: not in a case going through a light pipe or diffuser), 1 mA is actually pretty bright with modern LEDs. They're a lot more efficient than they used to be. For use as indicators for firmware debugging under typical office lighting, I find 1 mA to be the "sweet spot" - bright enough that I can tell it's lit with a quick glance, but not so bright that if I'm staring at the board it becomes uncomfortable to look at, or distracting out of the corner of my vision. However, if it's for indication for an operator of a device, and it's inside a case going through some lossy elements (eg: aforementioned light pipe or diffuser), I'll definitely use more current to make it a bit brighter.
- mlyle 7y agoI can't be sure it's "on" unless it leaves little 0603-sized purple spots in my vision. ;) (Maybe I'm biased because I often have my office window open and it's bright... and having couple orders of magnitude of current above what a microcontroller pullup/pulldown will source/sink has been nice sometimes-- that or I'm just stubbornly trying to justify following the very-old 4mA rule of thumb).