4 ms·
> The high frequency does mechanical damage to the cables How does it do this? Like, is it physical vibration driven by the EMF or what?
by taneq 7y ago
> The high frequency does mechanical damage to the cables
How does it do this? Like, is it physical vibration driven by the EMF or what?
- willis936 7y agoMy guess would be ohmic heating.
- londons_explore 7y agoA few tens of degrees hotter makes PVC plastic insulation go brittle much much faster.
- jacquesm 7y agohttps://www.allaboutcircuits.com/textbook/alternating-current/chpt-14/standing-waves-and-resonance/ https://www.allaboutcircuits.com/textbook/alternating-curren... Has this bit in it: "Transmission lines may be damaged by the high maximum amplitudes of standing waves. Voltage antinodes may break down insulation between conductors, and current antinodes may overheat conductors." I've never seen any proof of the first but the damage I've seen is consistent with overheating.
- someguydave 7y agoThe current and voltage in coax feedlines varies with length - he is probably looking at spots where current peaks and thus ohmic heating causes physical damage.
- taneq 7y agoHot spots was my first guess too, the emphasis on the damage being mechanical threw me off though.
- jacquesm 7y agoI should have used 'physical', my bad.
- CamperBob2 7y agoThe only way there should be significant nodes and antinodes along a transmission line is if the load match is (very) bad. Not sure why this phenomenon would ever happen in the real world, unless there's a mismatch problem. This is basically the definition of VSWR. No mismatch = no standing waves. If you're seeing a pattern of degradation due to uneven heating in a piece of coax, check the antenna.
- nullc 7y agoEven if the antenna is well matched when it's set up... is it still well matched while it's loaded with snow?
- jacquesm 7y agoAt high enough power levels that doesn't even matter. No antenna is perfect and even if it is when it is installed it won't remain so over time.
- someguydave 7y agoIf the coax is operated at max power handling capability with a good match, then it wouldn't take much reflection (anywhere in the system) to cause internal arcs or heating. No real component has an infinitely low reflection coefficient.