2 ms·
Cutting parts by hand isn't necessarily bad. But they should have gone to a design engineer and said "we're hand cutting these parts, and don't think we can ge
by londons_explore 7y ago
Cutting parts by hand isn't necessarily bad. But they should have gone to a design engineer and said "we're hand cutting these parts, and don't think we can get accuracy better than 1/32nd of an inch. Will that compromise the design?"
The engineer will then run a few tests and simulations, green-light the change, a superior will check the maths, and they'll be good to go with making the part by hand.
- krn 7y agoAccording to the same source: > But there was worse to come: every part in the production process has to be signed off at each stage of its manufacture on a document called a "shop traveller". This records that each individual stage of manufacture has been carried out in accordance with the type design. > The Boeing team discovered that Ducommun had apparently falsified these records: it had two sets of "books" - the official one recording that each part had been made by the computerised process and a second set recording the actual, handforming process which had really been used. > What that meant, in the eyes of the Boeing team, was that every single chord and bear strap manufactured by Ducommun had to be viewed as unlawful.
- Brakenshire 7y agoThese are core structural elements which rely on the quoted level of tolerance.