3 ms·
To begin with, Tesla's "motor controller" is an inverter. The charger on board is AC-DC. DC-DC It's an old, but still not completely solved problem: imagine yo
by baybal2 7y ago
To begin with, Tesla's "motor controller" is an inverter. The charger on board is AC-DC. DC-DC
It's an old, but still not completely solved problem: imagine your stack open, but for a single FET, and your resistor is a little bit off. It instantly pops, and the "tuning" for the rest of it is now completely off, and it will cascade further
In case of Tesla, they do use the exotic semiconductor materials I mentioned above. SiC goes to 1500V nominally
You need to learn electronics engineering beyond wiring Arduinos
There is old, but still quite good and relevant explanation why stacking FETs suck on edaboard https://www.edaboard.com/showthread.php?269261-Is-MOSFET-in-series-is-possible https://www.edaboard.com/showthread.php?269261-Is-MOSFET-in-...
There is an even older, but still excellent paper published by Philips called "Power Semiconductor Applications" where they explored nearly all trick to make FET stacks to work reliably.
Short: it's near impossible to do it reliably with off the shelf part, and it's better to not to risk if you deal with 600A+ currents. And if are determined to do all tricks necessary, IGBTs or III-V materials will still win on simplicity and cost