2 ms·
I think you will find that if you put the effective non-glass surface area of a model 3 in direct sunlight... Half of the car will be in shade. Half of the car
by walrus01 7y ago
I think you will find that if you put the effective non-glass surface area of a model 3 in direct sunlight... Half of the car will be in shade. Half of the car will be angled at a less than optimal angle (such as 35 degree fixed tilt, aimed directly south, for a ground mounted PV install). I would be extremely surprised if a model 3 or S covered in PV cells produced anywhere near 2000W in direct sunlight.
My best estimate is that it's a really charitable back of the napkin figure to say that a model S sized vehicle with every square cm available of body panel covered in PV cells might be equivalent to four 250W panels.
The math is, roughly, and this is output from 30 seconds with the pvwatts tool. This is for a fixed ground mount or roof mount array of 4 x 250W panels, tilted at 20 degrees aimed directly south. Not on a car.
Worst month of the year, december: 97kWh produced
Best month of the year, july, 165 kWh produced.
Screenshot: https://imgur.com/a/OcK8z2b https://imgur.com/a/OcK8z2b
Keep in mind, that production estimate is for four panels that have unobstructed view to the sky 24x7 for a month, and begin receiving sunlight as soon as the sun comes up in the morning, and keep receiving it every minute of the day until the sun sets. Every day for a month. Not how you would see a car used.
Probably a lot less than that, since any high efficiency PV cells are not curved, and if you're talking about surfaces that are curved in more than one axis, that entirely rules out using big 156mm monocrystalline Si cells. And there's no way in hell that anyone can afford to be using 33% efficient space grade GaAs PV cells on a car.
Ignore the panel cost? Have you ever actually priced gallium arsenide triple junction PV cells?
If you have actually installed and put into use an off grid PV system and watched its output through a whole solar day, you would understand.
- Retric 7y agoThat’s assuming you’re stuck with the shape of a model 3 rather than building a model 3 sized car. The aerodynamics suck, but a VW camper had basically a flat roof on top of a rectangle. The roof is not going to have an ideal tilt, but side panels will provide real value. In reality you are not stuck with full sized panels so as long as you avoid long curves you can still have a reasonable shape. PS: Fairly high efficiency flexible pannels are also available. https://portamaxpower.com/products/330-watt-high-efficiency-lightweight-flexible-solar-panel/ https://portamaxpower.com/products/330-watt-high-efficiency-... Which you can use in some areas to have a more aerodynamic design without sacrificing much solar efficiency.
- walrus01 7y agoBuy one of those and try flexing it. I have held similar products in my hands. It's still built from individual 125mm sized monocrystalline si cells. It's a little bit flexible, but not like you think, and certainly not going to curve to fix a multidimensional curve of a car body panel. It's not flexible like a vinyl car wrap, or even the material of a zodiac boat, it's flexible in the same way that a 1cm thick foam insulation board is flexible. It's also ridiculously expensive compared to the $0.48/watt STC cost of big 72-cell panels by the pallet load.