3 ms·
"bitness" is defined by the natural data size of common operations. The Z80 is 8-bit as most of its internal operations work over this data size and its regist
by dspillett 8y ago
"bitness" is defined by the natural data size of common operations.
The Z80 is 8-bit as most of its internal operations work over this data size and its registered are 8-bit. It can perform some 16-bit operations over two registers, but this is less natural to the design (based upon the 8-bit 8080).
The 8088 is 16-bit as its registers are naturally 16-bit even though there are also ways to address them as 8-bit halved. While the distinction between registers that are 8-bit but can be paired (Z80) or 16-bit but can be halved (8086/8088) may seem arbitrary on its own but looking into the instructions available and how they perform makes which side a chip sits on more obvious.
How much can be read at once is not the right differentiator, as it is essentially an interface issue. The internals of the 8088 are the same as those of an 8086, apart from those at the interface which break the 16-bit requests into 8-bit ones, they just have to wait longer for the signal that data has arrived/left.
Another common one that can confuse is the 80386SX: these are 32 bit chips (essentially the same design as the original 80386, latterly referred to as 80386DX) with a 16-bit data bus (so 32-bit requests are split as seen with 16-bit ones with the 8088) and a 24-bit address bus (limiting them to 16Mb physical memory like 80286 chips). These limited bus sizes allowed them to be used on motherboard designs originally intended for older 80286 units.
Other confusions come from specialist instructions: floating point operations using larger (40- & 80-bit) special purpose registers, SIMD instructions (such as those in the MMX set, introduced on 32-bit Pentium lines, operated over 64-bit collections of smaller values), etc.
Sometimes it works the other way around: the original Pentium lines (up to the Pentium 4) were 32-bit chips even though they had a 64-bit data bus (this made loading data into the L1 cache faster, rather than marking the chip out as 64-bit overall) and some 64-bit instructions.