3 ms·

My favourite DAW. Think I am going to have to invest in a new DC coupled interface with lots of inputs and outputs now to drive the modular.

• 33degrees 8y ago
  You're likely aware of this already, but the expert sleepers ES-8 is a great way to interface the two worlds.
  • brokenmachine 8y ago
    I don't know anything about modular, do you use this to route audio through modules? What's a typical use case for this? Custom audio effects, or is it mostly just to get audio back into the DAW from your modular?
    • twalla 8y ago
      You can route audio into/out of a modular synth with this but the main selling point is being able to send CV or control voltage signals from your DAW to your modular. CV is just DC electrical signal that represents some value you want to manipulate. Think of 0v representing the lowest note/frequency on the keyboard and 5v representing the highest, with all voltages in between representing intermediate values, or 0 representing a filter being set to the lowest frequency and 5 representing completely open, letting all sound through. Boutique analog equipment that can manipulate/sequence CV is usually pretty expensive, but with a module like this you can get similar/more functionality for less.
    • 33degrees 8y ago
      As twalla mentions, while it's useful for audio, it's especially good for control voltages, which most audio interfaces will filter out. As Bitwig has devices for sending control voltages, it allows you to control modules from the software.
• robbyt 8y ago
  I use a Lynx Aurora with CV from Bitwig, and it works wonderfully.