4 ms·
This is a great initiative! I'm using a similar setup. I have my ISP's router in bridge modus, an ERLite‑3 router by Ubiquiti, and a NAS server by Synology. It
by Fnoord 8y ago
This is a great initiative!
I'm using a similar setup. I have my ISP's router in bridge modus, an ERLite‑3 router by Ubiquiti, and a NAS server by Synology. It could've been a router by PC Engines, a Router7, an unRAID, or a Pi too. Ever since I got the Synology NAS (which can run Docker) my Pi is gathering dust.
The NAS runs Docker and uses PiHole(dnsmasq)/Unbound to take the main traffic. The ERLite‑3 router is second choice and uses PiHole/Unbound as well. The setup provides redundancy. All DNS traffic not generated by the router and not coming from the NAS is redirected to the NAS. Both PiHoles have each other as redundant server as well. Both utilize Quad9's DNSSEC servers with DNS over TLS [1]. Though I suppose ideally you want DNSCrypt [2] this should also be possible with Quad9. The advantage this is going to work on any client. Since the ERLite‑3 allows WireGuard (and only that; no OpenVPN or OpenSSH or anything) clients such as my smartphone or laptop have secure and ad-free internet. Since I'm also using Quad9's blocklist, things such as porn are also blocked. The only caveat is that these clients have access to my LAN. While that's intentional, it increases the attack surface of my devices. I shouldn't trust my wife's devices on the LAN remotely. Then again, all internal LAN services are behind strong passwords.
[1] https://www.quad9.net/faq/ https://www.quad9.net/faq/
[2] https://dnscrypt.info/faq https://dnscrypt.info/faq
- wil421 8y agoDo you lose any bandwidth in bridge mode? I’m about buy a new Ubiquiti Edge router and a few APs. With AT&T I can’t do a true bridge mode or use my own modem. Their gateway has to do the authentication to the network and I’m stuck with it if I want gigabit fiber. People on dslreports lost a good bit of bandwidth on a gigbit connection writing rules on the edge router to authenticate back through the gateway.
- anjbe 8y agoReportedly you can max out gigabit AT&T even if you proxy the authentication bits through the router: https://www.reddit.com/r/openbsd/comments/aaz2rf/openbsd_router_directly_connected_to_isp/ecwd2a1/ https://www.reddit.com/r/openbsd/comments/aaz2rf/openbsd_rou...
- wil421 8y agoFantastic. It’s only 15 days old too.
- Fnoord 8y ago> Do you lose any bandwidth in bridge mode? If you put your ISP's router in bridge mode: no. If you put the Ubiquiti router in bridge mode: yes (but it allows you to have bridging between WLAN and LAN whilst still on separate ports).