5 ms·
Power-only USB cables offer good data protection, or just set your device in such a mode.
by karmakaze 8y ago
Power-only USB cables offer good data protection, or just set your device in such a mode.
- geofft 8y agoNo such devices exist with USB Power Delivery support, I believe. (I believe you cannot make a passive adapter as you could for 5V, 2A-or-less plain USB A/B power connections; you have to speak the USB protocol and register as a device before you can switch to more than 5V or draw more than 2A. And plenty of people want more than 10W power.) I also don't believe any OSes offer a mode where they negotiate power delivery and not data, though I'd love to be wrong - that would be 90% of my proposal. It wouldn't let you authenticate individual devices, but it would let you go back to having a single port that's just a charging port.
- gumby 8y agoYou can buy type c condoms that do all the negotiation but block data to and from the cable.
- geofft 8y agoDo you have a link to such an item? All I have found is devices that lower you to USB A-style 10 W charging.
- cesarb 8y ago> you have to speak the USB protocol and register as a device before you can switch to more than 5V or draw more than 2A. It depends on which "USB protocol" you're talking about. With USB-C, there are five separate data buses on the plug, each running its own protocol. There is the traditional USB 2.0 bus (half-duplex differential pair), a pair of differential dual simplex buses (normally USB 3.0/3.1/3.2, can also be used for alternate protocols like DisplayPort), a pair of sideband wires (used only by alternate protocols), and the Configuration Channel. All configuration of the other data buses and of the main power bus is done through the Configuration Channel, in simple cases through resistor values, in more complex cases through the USB-PD protocol. So yeah, you have to speak the "USB protocol" to switch to more than 5V or more than 3A, but the "USB protocol" you have to speak is not the traditional USB 2.0 or USB 3.x protocol, but instead the completely separate USB-PD protocol, which runs on its own dedicated set of wires. I doubt you can show up as a pen drive full of malware through the USB-PD protocol, but I don't doubt that cutting the other buses (keeping only the Configuration Channel/VCONN and the main power bus) will still work to deliver power, even at higher voltages and/or currents. The reason this isn't standardized (as far as I know, a "charging-only" plug is only allowed as a captive cable on a non-charger) is for compatibility: if your device doesn't understand USB-PD, it might not charge at a full speed unless it sees a short on the USB 2.0 bus (Battery Charging specification), and doing that short on an adapter would allow a device to draw too much power from a non-charger.
- anticensor 8y ago18V, 5A would be a shock hazard.
- XMPPwocky 8y agoIf you stick it in your mouth or something, maybe. Or if you're soaking wet and have a terrible heart. Otherwise, nobody's getting hurt off 18v.
- gsich 8y agoNo. Skin resistance is at least around 100k Ohm at that voltage.
- semi-extrinsic 8y agoDC voltages below 50 V are considered "safe" in normal indoor conditions. It's often referred to as "extra low voltage", as opposed to "low voltage" (50 V - 1000 V) and "high voltage" ( > 1000 V). If you want to verify the safety of 18 V: ever touch both poles of a 9V battery with your fingers? You can't feel anything. Go ahead and try two in series, you still won't feel it.
- naikrovek 8y agoReally? I can feel 4 volts between my finger and thumb. Isn't painful or anything, but I can tell when a lipo battery is charged vs. discharged.
- Maskawanian 8y agoYes, here is a good video about this: https://www.youtube.com/watch?v=ZxBF7WC0TQk https://www.youtube.com/watch?v=ZxBF7WC0TQk
- xxs 8y agoYou can feel lower voltages if you fingers are injured, or if you... lick them. As kids (6-9y) we used to test the voltages of 3R12 (4.5v) by touching the poles with tongue, a sharp bites - the battery was good.