For hand assembly I usually break out all of the components into little iFixIt project trays and print out labels that correspond to the board, but when there a

For hand assembly I usually break out all of the components into little iFixIt project trays and print out labels that correspond to the board, but when there are a bunch of components with the same value, I just put the value on the label instead, and use highlighters on to point them out on printouts so I don't spend forever hunting where to place them. Then, I just go one by one down each spot in each tray until I've populated a board, then I throw it in the oven and start on the next. https://pbs.twimg.com/media/DvIU0gSXQAE883Y.jpg:large https://pbs.twimg.com/media/DvIU0gSXQAE883Y.jpg:large https://pbs.twimg.com/media/Dv2KXBuW0AAQY5c.jpg:large https://pbs.twimg.com/media/Dv2KXBuW0AAQY5c.jpg:large