4 ms·
I always thought it would be a fun project to replace the SRAM with MRAM, but MRAM is all 3.3V or less and GB and NES SRAMs were typically 5V.
by aidenn0 8y ago
I always thought it would be a fun project to replace the SRAM with MRAM, but MRAM is all 3.3V or less and GB and NES SRAMs were typically 5V.
- jacquesm 8y agoThree diodes in series should take care of that, and if you find you need to step up the output voltage it should be possible to either put some fast buffers in between or, alternatively, to replace whatever buffers there are already on the board with ones that are more tolerant to voltage differences on their inputs. It remains to be seen how mcuh the MRAM will like the 5V inputs, that is something the datasheet should be able to clear up.
- aidenn0 8y agowhatever it is would have to be bidirectional, since the same pins are used for input and output. They probably make a level converter designed specifically for sram, but I haven't had time to look for one.
- jacquesm 8y agoA 245 or something like that, of course the speed requirements will be critical. It will be a tricky modification to do properly if you want reliability. In the end it might not be worth it.
- aidenn0 8y agoFor gameboy, the pokemon cartridge I checked uses a Hyinx GM76C256CLFW, which is 85ns for address acquisition and 45ns for output-enable to valid data. Tightest timing is it requires only 5ns for ~OE being asserted to the outputs being high-Z. It doesn't multiplex address and data pins, so there are only 8 pins that need bidirectional conversion. The TI SN74LVC8T245 has a max time for OH on the 5V pins of 10ns, which is probably good enough. All the NES games I just tried to check require a security bit I don't have to open, so I couldn't check any of them. [edit] I ordered the right driver bit and amazon suggested CR2032 batteries, which I found amusing.
- jacquesm 8y agoCool, curious how that will work out.