5 ms·
This is a very good comment, but I think your joke needs to be explained for most people out there. "Sense Amplifiers" are the part of "DRAM" which can perpetua
by dragontamer 8y ago
This is a very good comment, but I think your joke needs to be explained for most people out there. "Sense Amplifiers" are the part of "DRAM" which can perpetually hold a charge.
The rest of DRAM are tiny capacitors (kinda like batteries) that can only hold a charge for 64-milliseconds. Furthermore, a SINGLE read will destroy the data. So the DRAM design is to transfer the information to "sense amplifiers" each read, and then to transfer the information back at the end when the "row of data is closed".
Once you understand that DRAM capacitors are so incredibly tiny, RAS, CAS, PRECHARGE, and REFRESH suddenly make a LOT of sense.
* "Row" is all of your sense amplifiers.
* RAS: Transfer "one row" from DRAM into the sense amplifiers.
* CAS: Read from the sense amplifiers
* PRECHARGE: Write the sense-amplifiers back into DRAM. Sense-amplifiers are now empty, and ready to hold a new row.
* Refresh: Sense-amplifiers read, and then write, a row to "refresh" the data, as per the 64-milisecond data-loss issue. According to Micron, all Sense Amplifiers must be in the ACTIVE state (ie: after a Pre-charge. They are empty and ready for reading / writing of new data).
> Could you put in NM amplifiers to refresh all the cells at once? Sure, but then we would call it SRAM :-)
Indeed. Sense Amplifiers are the "part" of DRAM which act like SRAM. Sense Amplifiers do NOT lose data when they are read from. They do NOT need to be refreshed. Etc. etc. Sense Amplifiers are effectively, the "tiny" SRAM inside of DRAM arrays that makes everything work.
The very point of "DRAM" is to make most of your RAM be these cheap capacitors. So the only solution is to read and write data to the sense amplifiers, as per the protocol.