3 ms·
Hope it's OK to go off topic a bit and vent my gripe about connectors: You bump the connector and destroy the printed circuit board that it lives on. Well, at
by analog31 8y ago
Hope it's OK to go off topic a bit and vent my gripe about connectors: You bump the connector and destroy the printed circuit board that it lives on.
Well, at least I got an oscilloscope for free that way. The inputs were flakey, and it was rejected by the calibration service. I opened it up, and re-soldered the printed circuit mounted input connectors. Lovely scope.
- oasisbob 8y agoI think it's very on topic - connector mounting and robustness is important. BNC connectors hit a great sweet-spot of being cheap and easily available for bulkhead mounting. I've used them for power in data loggers before, since they're positive locking. Felt a bit dirty, but just pretended I was in a research lab where BNC for DC power is very common.
- wmf 8y agoReliability isn't really off topic when talking about connector design. Apparently there are possible tradeoffs between damaging the socket and the cable; IIRC micro-USB is designed to sacrifice the cable to reduce damage to the device.
- tonyarkles 8y agoFunny enough, I had a $1200 software-defined radio that was destroyed when the micro-USB3 connector ripped off the board, taking a bunch of traces with it. When I ordered the replacement, it came with a full-sized connector on it instead, with mechanical through-hole structural support. Some micro-USB connectors have the through-hole support, but many are pure SMT devices that will happily destroy your board with a sneeze.
- gumby 8y agoThe interesting thing about BNC is that the strain relief is with the device chassis, not the boards themselves. This makes them enormously more robust than, say, a PCB mount HDMI or anything like that.