4 ms·
>> surely they could tumble at a much slower rate and waste less electricity. Tumbling uses a fraction of energy heating does. The motor used for rotating the
by gambiting 8y ago
>> surely they could tumble at a much slower rate and waste less electricity.
Tumbling uses a fraction of energy heating does. The motor used for rotating the drum will use about 20-30W, while the heating element will be rated at 2000-3000W.
I suppose it could use less heat for longer, but then I'm not sure if it actually works out favourably(as in - if you just use 1000W of heat, is the process 2x as long, or longer? Because if it's longer or the same then it's more efficient to use full 2000W of power for heating).
- chendragon 8y agoThe motor for the dryer also needs to power the fan that draws air through the unit. Without anything attached to the shaft, I previously measured the no-load power of the electric motor to be 200W. I would expect the full load current to be considerably higher, as the dryer's drum rides on friction pads and not ball bearings.