4 ms·
You need multiple passes, because while doing the first pass, contact is still being made on an angle. Tie all the nuts at least once, then you won't have an an
by NullPrefix 8y ago
You need multiple passes, because while doing the first pass, contact is still being made on an angle. Tie all the nuts at least once, then you won't have an angle and will be able to tighten better.
Same like you should do on your car wheel. First put them all ass much as you can without force, then apply force. In a star bolt pattern.
- insomniacity 8y agoI suspect the other element is that if the line fails completely in the middle, the new splice is now structurally critical to holding the line up - so you need it to be as good, or better, than the original manufactured line.