3 ms·
That’s a pure waste of equipment. A maximum power point tracker can simply move away from the maximum power point to reduce production. Essentially every solar
by amluto 8y ago
That’s a pure waste of equipment. A maximum power point tracker can simply move away from the maximum power point to reduce production. Essentially every solar installation has an MPPT. The only insteresting bit is figuring out when and how much power to avoid producing, and it’s exactly the same problem as figuring out when to dump power into a dump load.
A case where a dump load is important is small scale hydroelectric power. If you try to draw less than full power from the turbine, the turbine will start spinning faster and faster. So you can use (slow and complicated) valves or mechanical brakes, or you can use a dump load.
An interesting case I don’t fully understand is how an off-grid (islanded) SolarEdge system handles a full battery. If I understand correctly, the SolarEdge modules independently track the maximum power point and produce an output voltage of P/I where I is the current drawn by the inverter. So, if the inverter draws less current, the string voltage will increase and the same power will be produced. I think SolarEdge targets 450V for the string, so, even if the modules have a maximum output voltage, there’s not a lot of head room before the string hits 600V and risks exceeding the wire insulation rating. My guess is that the inverter will turn the array off entirely when the battery is too full. Or perhaps the modules have a smallish current limit, and the inverter can reduce its effective input impedance if it needs to curtail production.
- sathackr 8y agoThe SolarEdge system I have targets 380v. At power up, it runs the string voltage up to 500v to test for isolation(short-to-ground) issues. It has a mode that can temporarily run the string voltage up to 1000v to meet testing requirements in some jurisdictions. Each panel has a "Power optimizer" installed -- basically just a DC-DC converter that has active communication with the inverter. It should be able to control the power production of the entire system by limiting the current supplied by each module, though I don't know for sure that this is how it does it.