3 ms·
Nice thought, but not in my book! Once you need to work with real precision, the US system is even more awful. From an exactly 12" wide board, you cannot get
by toss1 9y ago
Nice thought, but not in my book!
Once you need to work with real precision, the US system is even more awful.
From an exactly 12" wide board, you cannot get three 4" pieces, since the saw kerf width is nonzero. It gets worse when you work with "standard" dimensions. A common 2x4 is actually only about 1.5" x 3.5" (and I don't think even the big sawmill blades take that big a kerf), and similar discrepancies all over.
And converting drill bit sizes? Don't even start; it's either tables or a calculator.
Whenever I get metric projects it's always such a pleasure. I wish we'd get our act together and switch...
- InitialLastName 9y agoBut... none of those issues have to do with imperial units. If you have a 30cm wide board, you can't get 3 10cm wide pieces either. And 2"x4" in lumber sizes refers to the size of the lumber prior to drying, treating and planing, all of which shrink the wood a bit. What is it about metric projects that makes those issues go away?
- toss1 9y agoGood point - it's not so much that the issues of accounting for the kerf go away, they're just easier to deal with in decimal. I usually am using materials like structural foam, carbon fiber, or metals, just used wood as an easy example. And I'm using higher precision than most carpenters, so typically measuring with a micrometer which reads out in 0.001in (or 0.01mm) units. You can't just go from 1x12in to 3x4in pieces, you have to knock off maybe 5/64in for a kerf, which is 0.078125in so to get 3x 4in wide pieces, I'll need a board which is 12+5/32... Lots easier to work with 1.984mm so for my 3x 10cm pieces I'll need a 304 mm wide board. The bottom line is that once you get precise, the fractional regime which is indeed often easier to divide out by 1/2, 1/3, 1/4, 1/5, 1/6... etc. turns out to be no use at all because you can never actually use those nice fractions, and you're in a decimal regime with lots of fractional conversions (some micrometers even have a fractional inch readout mode, but it turns out to be not all that useful.) Once you're in decimal, it's WAAAAY easier to be in metric all the way.