2 ms·
I like this Weller document: https://www.astro.umd.edu/~harris/docs/WellerSoldering.pdf https://www.astro.umd.edu/~harris/docs/WellerSoldering.pdf This is aime
by DanBC 9y ago
I like this Weller document: https://www.astro.umd.edu/~harris/docs/WellerSoldering.pdf https://www.astro.umd.edu/~harris/docs/WellerSoldering.pdf
This is aimed at people soldering through hole, not surface mount, components.
Really, it's not that hard. I'm clumsy, but I could solder pretty well. Buy an iron. Get hold of old scrap circuit boards and some cheap components and some solder. For beginners you'll want to try to get tin/lead solder with built in flux.
People will recommend some very expensive stations, and those are nice, but you don't really need them. Just get something for electronics work, and avoid the cheapest products.
Apply a tiny bit of solder to the hot tip, put the tip on the joint, apply the solder, remove the solder, remove the tip. You're heating the joint which heats the solder. You need to do this somewhat rapidly to avoid damaging the pads and overheating the solder.
When you buy a kit it'll come with wire. That wire is probably going to use PVC insulation. You'll need to practice soldering PVC wire. You can buy a whole reel for quite cheap. PVC insulation will "shrink back" when heated. Practice will help. (As will rubber sleeving to go over those joints. Here's one example of a product, but there are many: https://www.canford.co.uk/Products/39-420_HELLERMANN-SLEEVES-H20-Black-pack-of-100 https://www.canford.co.uk/Products/39-420_HELLERMANN-SLEEVES...)