1) What are the proper switch settings for the last disk drive in a chain? 2) What are the proper flyback time and front porch settings for a 60Hz 480/320 disp

1) What are the proper switch settings for the last disk drive in a chain? 2) What are the proper flyback time and front porch settings for a 60Hz 480/320 display? 3) What is the latency of fetches from your plated wire memory? 4) What resistor should be cut to change from a current-loop to voltage-loop TTY on a DEC controller board? 5) How do you specify a library as private on a JCL control card? 6) What is the TECO command to erase the last line? 7) What are the most common modem settings to communicate at 9600 baud? 8) What is the most likely failure mode of an IBM Series 1? 9) What is the front panel switch sequence for cold-booting a PDP-8? 10) How do you specify segment swaps in an overlay loader? 11) What patch panel plug configuration should your card sorter use to sort on column 4? 12) How can you dynamically change the output format statement in Fortran? 13) How do you modify a floppy to write on both sides? 14) What does an "imprecise interrupt" mean on an IBM Mainframe? 15) How do you find a failing instruction using the PSW? 16) How would you write a COBOL instruction to generate a hardware translate-and-test instruction? 17) What is the proper hole pattern in a paper tape to generate NOP? 18) Write a Register-to-Register move instruction for a PDP-11 19) What is the BASIC instruction to modify memory? 20) What is the seek sequence that will physically move a BASIC-4 disk drive cabinet? (provide all answers in EBCDIC)