3 ms·
We learn through mistakes, releasing magic smoke can teach a lot, so the first suggestion is to be prepared for failures: don't let them discourage you but rath
by squarefoot 9y ago
We learn through mistakes, releasing magic smoke can teach a lot, so the first suggestion is to be prepared for failures: don't let them discourage you but rather use them to learn more.
Stay away as much as you can from microcontrollers and ICs, at least until you have grasped enough knowledge and handling/soldering capabilities. I'm very serious, stay away from Arduinos, Raspberries and everything like that. There will be a time for them. Opamps and logic ICs also are a vital part of electronics, but starting with them would do more harm than good. Get a book for basic electronics (No, The Art of Electronics although wonderful is not a good choice now).
Start with simple stuff to get an idea of what the Ohm Law means, that is, some resistors, a battery and some multimeters. While for serious stuff a Fluke is worth more than a billion cheap Chinese multimeters, having 3 or 4 of the latter will be immensely more useful than a single top brand one because seeing in real time the battery voltage and what develops around a voltage divider when you change the resistors ratio has no price.
Same for instrumentation: an oscilloscope is worth the information you get by using it, so you have first to know what it does measure, otherwise it's not even worth a 5 bucks Chinese multimeter.
https://learn.sparkfun.com/tutorials/voltage-dividers https://learn.sparkfun.com/tutorials/voltage-dividers
Try the voltage divider with a 9V battery and measure everything, the total current the battery voltage and both voltages on resistors wires. Change resistors and take note of what changes and try to find out why. Use from very low value resistors to very high ones maintaining their ratio and watch what happens to current and voltage.
Now swap a resistor with a led. Does it light or not? Was it inserted the right way? If yes why doesn't it work? If not why it still doesn't work? What's the resistor value and how much current is flowing through the led?
Measure voltage and current, choose the wrong resistor and burn some leds -> learn more.
Put a high value capacitor in parallel to the led, why the led turns on and off slowly when connecting/disconnecting the battery? Again measure voltage and current: why current increases before voltage when battery is connected?
Build a solenoid by winding from tens to a hundred turns of enameled copper wire around a big iron nail, then connect the battery with some iron small screws or iron powder near the nail head, what does happen and why?
When you remove the battery do you see a small spark? Why?
All those experiments though can be performed with very little money will put you on the right track.