3 ms·
Firstly, these displays promise brighter colors and a wider gamut. Secondly, you only get long battery life in a small package one tiny step at a time, and you
by Someone 9y ago
Firstly, these displays promise brighter colors and a wider gamut.
Secondly, you only get long battery life in a small package one tiny step at a time, and you want them, either to increase battery life or to make smaller watches. The latter is particularly hard. A typical smart watch is around 10 mm thick, nowadays, 2 or so of which are taken by the display and the back panel. So, if you want to make it 8 mm thick, you lose 25% of inner volume and, ballpark, the same on battery volume (taking into account that the battery is shielded, likely closer to 30%)
Finally, I’m not sure that transflective display is that low power if you want to frequently update the display. Looking at the data sheet of https://eu.mouser.com/new/Sharpsma/sharpmemorylcd/ https://eu.mouser.com/new/Sharpsma/sharpmemorylcd/, page 14 lists power use of 15 μW on a static display, 50 μW on a display that updates at 1 Hz. Extrapolating, I get 2115 μW at 60 Hz, or about 2 mW. The capacity of a typical smartwatch battery is less than 1 Wh, so that display could display video for 500 hours or 20 days (rounded up a few times)
- utopcell 9y agoWider gamut is what might be the differentiator here. With respect to power consumption, the video codec would probably draw more than 100mW [1], and at that point, the 2mW display consumption would not matter. [1] a 640x480@15fps hardware decoder draws 71mW. https://cseweb.ucsd.edu/classes/fa11/cse291-a/pdf/02/JSSC_stacked_mobile.pdf https://cseweb.ucsd.edu/classes/fa11/cse291-a/pdf/02/JSSC_st...
- Someone 9y agoThe display i mentioned is 144x168. 640x480 is over 12 times as many pixels. _if_ decoding scales by #pixels, that would move that 71 mW down to around 6 mW. Still larger, more so if you go to 30 Hz or higher, but there is no silver bullet if you want a smaller watch or longer battery life.
- utopcell 9y agoEven assuming a CPU that would only consume 6 mW when decoding video, and nothing else (DRAM, wireless) draining power, then (at 15fps) the display is only drawing 0.5 mW, or 1/12-th of the CPU power consumption. Even if you were to assume a display that draws no power, that would only increase battery life by 8%. A more realistic estimate would be 1% to 2%. Nothing revolutionary about that.