4 ms·
Having watched similar series in the past, I would highly recommend some extra effort be put into the presentation - recording videos with no attention to light
by falcolas 9y ago
Having watched similar series in the past, I would highly recommend some extra effort be put into the presentation - recording videos with no attention to lighting or sound makes it really hard to see and hear what's going on. Specifically for me, it's really hard to understand what's being said over the keyboard and reverb.
Some basic lighting (so your face isn't in shadows), a separate directional microphone (even a $40 snowball would help immensely), and potentially some sound baffling in the room would make a real difference to the video quality. Finally, dark colors with low contrasts encode quite poorly on YouTube; some of the code is rather hard to read.
I realize we're watching a software engineer and not an entertainer, but the payoff in the quality of the videos for relatively little effort and investment is remarkably big.
- Xeoncross 9y agoI second fixing the audio. If $50-100 USD for a nice setup is too much, then for $7 off amazon you can get a clip-on, lavalier microphone for your shirt that sounds a lot better and plugs right into your computer. https://www.amazon.com/gp/product/B0727Z8TMX https://www.amazon.com/gp/product/B0727Z8TMX
- sneak 9y agoOr just pair a bluetooth headset and use that instead of the mic that is physically attached to the keyboard.
- yani 9y agoI haven't had any issues with the audio. How are you listening to it?
- nicky0 9y agoThe voice is reasonably clear but the loud keyboard tapping is a problem. A voice microphone not attached to the keyboard would help that.
- mikekchar 9y agoAs someone who has spent a fair amount of time playing with this, post processing audio is a big win. I use audacity and perform the following effects (the order is important): - Noise reduction - Compressor with "Make-up gain for 0 db after compressing turned off". - Equalisation with a curve that starts at -6 db at 20Hz, peaks at 6 db at 150 Hz and then curves down to -30 db at 20000 Hz. - Normalise with Remove DC offset and normalising at -0.1 db (0.0 db sometimes leads to problems for some reason). - Amplify if you need it (usually I don't) The logic here is: Noise reduction, to reduce hiss, key clicks, etc, etc., Compressor to squash the low and high amplitudes (turning off making up the gain also forces it to squash in a certain direction... I forget which at the moment, but it's important), Equalise as a kind of nicer low pass filter that gets rid of the noise reduction artefacts and other noises that make it through, Normalise to bring the amplitude back up that was knocked off by the compress (but in a nicer way than amplify would give you). Finally just fine tuning with amplify. I usually re-encode in FLAC and then mix it back into my video using my video editing software (I use Kdenlive). The difference in audio quality is unbelievable. You need to fiddle around a bit with the settings for your voice/environment, but I highly recommend giving it a try.
- jerrre 9y ago> - Equalisation with a curve that starts at -6 db at 20Hz, peaks at 6 db at 150 Hz and then curves down to -30 db at 20000 Hz. this seems like a very bad idea, this will give you very dull, boomy sound, for most recording setups. It's a bit too much work to type out everything here, but this is not good advice. Most of the time the best improvements are to be made with getting a decent microphone and set it up properly (doesn't have to cost much more than $100).