3 ms·
> Some people swear by PTFE insulated magnet wire. This should be “stripped” by the heat of the soldering iron… I just can’t get comfy with it. Magnet wire is
by DanBC 9y ago
> Some people swear by PTFE insulated magnet wire. This should be “stripped” by the heat of the soldering iron… I just can’t get comfy with it.
Magnet wire is enamel insulated. You can burn it off, but scraping it with a scalpel is probably better.
You can buy PTFE wire. You should not attempt to burn off the insulation. That would release harmful smoke. PTFE wire is a good choice for a beginer because the insulation is harder to burn and it doesn't shrink back with heat, unlike PVC. It's a bit harder to use otherwise - it's harder to strip, and the insulation is a bit stiffer than PVC.
Source: I used to build "chock control interfaces" that were full of PTFE wire looms.
This is a nice article with some useful advice for beginners. I think most important is to just get junk PCBs and practice taking things off, or putting things on. You really need to get some familiarity with how solder flows on different types of board or different components.
> Decide if you want to remount the component or re-use the rest of the device. We will take more care if we do.
When I was doing it we'd only ever remove faulty components. Often it's safer to chop the legs off, remove the body, and then you can use small amounts of heat to remove each pin. This protects the PCB, which is usually the expensive bit. (Especially if it's populated with components.)