3 ms·
> transistor logic which is relatively high current Huh? The gate resistance of a FET is hundreds of megaohms, so the input current is measured in nanoamps.
by lisper 9y ago
> transistor logic which is relatively high current
Huh? The gate resistance of a FET is hundreds of megaohms, so the input current is measured in nanoamps. That doesn't seem like high current to me.
- averagewall 9y agoTransistors in TTL logic use mA of input current because they're bipolar, not FET transistors.
- lisper 9y agoThat's true, but we're talking about computers here. Computer chips don't use TTL, they're all CMOS, which uses FETs (MOSFETs to be precise).
- kevin_thibedeau 9y agoCMOS didn't exist when the first transistorized computers were made.
- lisper 9y agoAh, right. I thought the OP was referring to modern CPUs.
- blattimwind 9y agoIn classic TTL the input currents are also very asymmetric, e.g. for a high level you mustn't draw more than a few dozen µA out of an input, for a low level you have to draw something like 1.5 mA or so. This is different from current-steering based logic (all kinds of ECL, including CML/SCL) were the current in the circuit stays the same, but only takes a different path depending on state. Supply current is largely independent of circuit state with these.
- userbinator 9y agoThat's the static resistance, but when it's switching there is current to charge/discharge the gate. Don't forget leakage currents too, which are quite high in modern CPUs --- they consume ~100A at ~1V when in active use.
- lisper 9y agoSure, but that is amortized over billions of transistors. If you had billions of vacuum tubes the current draw would be vastly higher.