4 ms·
Out of curiosity: what features did that fumes extractor have?! Mine has just a plain old switch to control the fan in 2 speed modes, and another switch to cont
by mschuster91 9y ago
Out of curiosity: what features did that fumes extractor have?! Mine has just a plain old switch to control the fan in 2 speed modes, and another switch to control the light...
- retSava 9y agoI guess the microcontroller controls a fan using PWM with a duty cycle depending on the mode. Even if you could do it with a 555, it's easier to just do it with a microcontroller. It also makes it easier to make changes up until production without changing hardware.
- lmilcin 9y agoNo, it controlled it through a Darlington array controlling an array of mechanical relays. The fan has 3 220V AC inputs and selecting the combination of inputs changes the fan speed. I haven't looked inside the fan because it worked correctly. I also didn't want to test it to see how it works so I figured it out by analyzing the PCB. Actually that was quite good idea because the relays seem to be connected in such a way as to only allow valid combination to be sent to the fan even in case of invalid input from the microcontroller. I suspect bad things would happen if I sent incorrect inputs to the fan -- looking at how crappy the board was but at the same time that the person put effort into placing the relays to explicitly disallow invalid combinations of power lines to the fan.
- lmilcin 9y ago3 speed modes, light, and some diode indicators. Previously there would be one switch to control light, 3 switches to control speed modes and extra switch that I don't exactly know what it did -- probably it controlled some kind of timer. The 3 switches that controlled modes were 0/1 (change speed to 1 if anything else than 1, turn off if it is currently 1), and 2 and 3 which would turn on 2 and 3 speed mode. I have added a 500ms long press to 0/1 switch which means that whatever is happening it turns off both light and fan at the same time. You don't have to turn off light and fan separately and you don't have to press 0/1 twice to reduce the speed to 1 and then to turn it off. As it was sometimes difficult to figure out which speed it was on without looking at the indicators (on the side and not on the front of the extractor) you never knew you had to press it once or twice which was quite irritating.
- nerfhammer 9y agonow, add a motion sensor so the light comes on when you stand near it and a smoke sensor so that it turns on automatically when you start cooking and stops automatically when all the smoke is clear.
- lmilcin 9y agoThe object was to place a new chip into an already existing PCB and then program it to work with the existing parts, switches, and so on.