3 ms·
Given that you have to request access to your data, then wait a bit of time before you can download lends credence to it being tape based, or at least something
by cortesoft 9y ago
Given that you have to request access to your data, then wait a bit of time before you can download lends credence to it being tape based, or at least something similar.
- hinkley 9y agothe power density of these data centers is so high that power and cooling may be your limiting factor. In which case having racks of hard drives where most of them are powered off half of the time would be feasible. But then you have to schedule powering up the right racks for the current set of requests.
- wlesieutre 9y agoSee Facebook's "Cold Storage" systems for an example of this https://code.facebook.com/posts/1433093613662262 https://code.facebook.com/posts/1433093613662262 > To get the most data into this footprint, we needed high density, but we also needed to remain media-agnostic and low-frills. Using the theme that “less is more,” we started with the Open Vault OCP specification and made changes from there. The biggest change was allowing only one drive per tray to be powered on at a time. In fact, to ensure that a software bug doesn’t power all drives on by mistake and blow fuses in a data center, we updated the firmware in the drive controller to enforce this constraint. The machines could power up with no drives receiving any power whatsoever, leaving our software to then control their duty cycle. > Not having to power all those drives at the same time gave us even more room to increase efficiency. We reduced the number of fans per storage node from six to four, reduced the number of power shelves from three to one, and even reduced the number of power supplies in the shelf from seven to five. These server changes then meant that we could reduce the number of Open Rack bus bars from three to one.
- hinkley 9y agoI remember that. It's like a drive carousel but without the arm. I also recall years ago reading about someone who was modifying RAID controllers to spin up the drives one at a time on a cold boot, because peak current draw occurs while spinning up the drives. They were getting brownouts when an entire array spun up at exactly the same time. So they spun them up over a couple of seconds and everything was fine.