5 ms·
Metal fabrication is my day job... To drill mild steel (regular old steel, containing 0.05–0.25% carbon, used for most things you see made of steel, like struc
by TheSpiceIsLife 9y ago
Metal fabrication is my day job...
To drill mild steel (regular old steel, containing 0.05–0.25% carbon, used for most things you see made of steel, like structural steel and most car body components) you need to use high-speed steel[1] drill bits, and they need to be sharp. With the correct speed and feed rate drilling mild steel with a power drill is quite doable, up to about 12mm diameter hole in 12mm thick plate.
Regular stainless steels, 304 and 316 grades, are drilled with the same drill bits but slower, lower feed rates, and with constant cooling using a cutting fluid.
I've seen people try to drill steel with drill bits intended for timber, or blunt drill bits, this isn't going to work.
YouTube has good videos of how to sharpen drill bits. Worth learning, but mostly impractical on anything below about 3mm diameter (1/8th inch).
1. https://en.wikipedia.org/wiki/High-speed_steel https://en.wikipedia.org/wiki/High-speed_steel
- dsfyu404ed 9y agoPretty much all off consumer tooling is HSS. People just use way too much speed and cook them. It doesn't help that most aren't too sharp to begin with. Ever since I bought a drill bit sharpener (faster for the same quality as doing it by hand on a grinder) I've been using my hss tooling more. For steel that just needs a hole and will be drilled with a hand (power) drill I've found that masonry bits are king. A small pilot keeps them from walking and the carbide tips hold an edge very well. For truck frame rivets in accessible locations it's faster and cleaner than a torch. The straight cutting edges are also very easy to grind.