3 ms·
Even if it was under compression against the outside ring, if the teeth were smaller than those of the outside ring, a force could cause them to rattle. That s
by falcolas 9y ago
Even if it was under compression against the outside ring, if the teeth were smaller than those of the outside ring, a force could cause them to rattle.
That said, if the difference in tooth counts is big enough, and the number of engaged teeth is high enough, you might get engagement from the teeth at the edges of the engaged surface, even if the inner teeth are a bit out of spec. This would cause some odd wear profiles in the teeth over time, though.
- TFortunato 9y agoIf I recall correctly (Not an ME - I'm more of an electrical / software side of the robot guy) -- between the flexibility of the spline gear giving a tight engagement, and the high preload / friction at the gear interface, you end up just backdriving the input if you try to jerk around the output shaft. They backlash may not be truly 0 (ask a knowledgable Mech E.), but they are definitely much better on that front than any other gearset with the same reduction I've ever got my hands on.