2 ms·
I really wanted to put OpenBSD on this old X1 Carbon 1st gen I had. I had trouble getting the installation with full-disk encryption working. The peeps in #open
by djsumdog 9y ago
I really wanted to put OpenBSD on this old X1 Carbon 1st gen I had. I had trouble getting the installation with full-disk encryption working. The peeps in #openbsd/freenode were amazingly helpful, but after a lot of debugging we came down to "Is your hardware working correctly? Have you tried to install anything else?"
I ended up putting FreeBSD on it and it worked great for a while. Then came the reboots, the lockups ... turns out I really should have run memtest86 first. The memory was bad; probably several other things too. I purchased it from a dodgy used shop and didn't realize all of this until past the 30 days. The memory on those models are soldered in too. I ended up eBaying it as a parts laptop.
Supposedly a fully functional X1 1st gen runs OpenBSD great. :-P
- saghm 9y agoI struggled a while back trying to get FDE on an OpenBSD install, and I think I did eventually get it working, although it took a good amount of time and effort. For comparison, back when I installed Arch with FDE for the first time, I found the documentation to be more than sufficient for getting it working relatively easily. Given OpenBSD's emphasis on security and the fact that the installer already can autopartition the hard drive its installing to, it would be awesome if the installer supported FDE in the installation without needing to manually deal with all the disk commands.