4 ms·
I don't know about the TMS99 series, but on the 6502 memory read could be as short a single cycle. The 6502 had a concept of a "zero page" which treated the fir
by cmrdporcupine 9y ago
I don't know about the TMS99 series, but on the 6502 memory read could be as short a single cycle. The 6502 had a concept of a "zero page" which treated the first 256 bytes of memory specially, with single cycle access. So they could be used as a kind of register.
But of course there was only one ALU, and to use it you had to use the Accumulator register.
- duskwuff 9y ago> On the 6502 memory read could be as short a single cycle… No, it couldn't. Even a NOP was 2 cycles. Memory access is at least 3 cycles for a zero-page read (read opcode, read immediate byte, read data), or more for the more complicated addressing modes.
- to3m 9y agoThe 6502 definitely reads or writes every cycle! - consult the data sheet (or VICE's 64doc) for more info. This is also not hard to verify on common 6502-based hardware. Suppose it executes a zero page read instruction. It reads the instruction on the first cycle, the operand address on the second cycle, and the operand itself on the third. 1 byte per cycle. (For a NOP, it reads the instruction the first cycle, fetches the next byte on the second cycle, then ignores the byte it just fetched. I think this is because the logic is always 1 cycle behind the next memory access, so by the time it realises the instruction is 1 byte it's already committed to reading the next byte anyway and the best it can do is just not increment the program counter.)
- duskwuff 9y agoOh, it certainly accesses memory every cycle. But the effective "efficiency" of the memory access instructions is much lower -- if you were writing something like a memcpy(), for instance, they wouldn't be contributing to its transfer speed.
- ksherlock 9y agoThe Renesas 740 (M740) 6502 variant had a T processor status bit which would cause certain instructions to operate on $00,X instead of the accumulator.