3 ms·
No. I charge the same rate. For travel to the client's location sometimes I will use a per trip rate instead of a per hour/day rate for trips to the client's si
by brudgers 10y ago
No. I charge the same rate. For travel to the client's location sometimes I will use a per trip rate instead of a per hour/day rate for trips to the client's site. I stopped discounting rates years ago because it does not help me and encourages the notion that it might be ok to not pay me or pay me less in a client's mind.
Because my rate structure is simple. I can describe it easily: W per hour/day. X markup on expenses. Y per mile travel. Z as retainer applied against final invoice based on my non-binding estimate of the time it will take to do the project based on the client's description (often Z is from 25% to 50% of the initial non-binding estimate). Most projects take at least K hours/days.
I don't wait for a potential client to bring up rates. Once it is apparent that the person is soliciting services, I describe my rates. This avoids wasting both our time when there is a gap between a potential client's economic expectations and my rates. It avoids wasting my time with potential client's who balk at writing me a check to get started...willingness and ability to pay are features of a good potential client. Execution of payment is a better criterion than a signed contract for separating actual clients from potential clients. A reluctance to pay me is a good criterion for distinguishing bad clients.
To put it another way, the essence of consulting is the business of "nickeling and dimeing" clients. And in general, charging money is the essence of business. A reluctance to charge people money is not wrong but it is at odds with trying to run a business.
The flat rate up front replaced my previous system where I would tell the client that I would follow up with a proposal and then spend time researching and pondering and estimating and then putting together a document and then waiting for the client's response or non-response.
Good luck.
- Communitivity 10y agoAgreed, and the above is important advice, because there is a bias on the part of potential clients. If you do not charge them for what they expect to be charged then that makes them uncomfortable with hiring you. In other words, if your rate is lower or you give them freebies they weren't expecting, then they think you are are having trouble getting work - and what do the other potential clients passing on you know that they don't? Sometimes they think this consciously, sometimes subconsciously. In a way, it is like dating.. your potential date has to feel appreciated, but not so appreciated that you look desperate. I see this in starting consultants all the time, though usually it is as a discounted rate rather than out and out not charging for somethings. These consultants don't realize that they are telling potential customers 'I value myself at X, less valuable than my competition'. They also don't realize that once you give a customer a rate it is difficult to raise the rate later and retain the customer (it can be done, but puts stress on the relationship). My advice is to charge what you are worth. One way is to figure out how much you would be making in a corporate job, not as a self employed freelancer. Say $160k. Now, once you go self-employed you will need to pay an addition 6.2% (12.4% total) for social security on money up to $118k, 2.9% for medicare, and to be safe you should allocate 25% to health care costs (seems unreasonable, but it does add up - you can trim here to match your health, but it would be better to sock away any extra in a given year). Back of the napkin, and very roughly, that means you need to be making $261k to approach the same take home (261000-(.25 x 261000)-(.124 x 118000)(.029 x 261000)-(.05 x 261000)). Given that if you work 8 hour days (not likely), and allocated 25% to overhead, that gives 2000 hours * 75% = 1500 hours, and a rate of $174/hour. However, your overhead might be more, and there are other costs (such as liability insurance). Also, you will be better off if you charge by the week, rather than the hour, because your accounting will be much simpler. I am neither an accountant, nor a lawyer, so consider the above my personal opinion and do your own due diligence before starting down this road. It is a great road, and managed properly can be successful. Beware though, it is high stress, and will eat up your time with your family.
- troels 10y agoI would say this formula only derives the minimum reasonable rate as a freelancer. It basically ends up netting you the same as you would in a salaried job (adjusted for risks/expenses). But I would say you should be making at least a bit more this way, for it to make sense as a career path. For comparison, I'm working as a contractor now and making between 2 and 3 times what I could make in a perm position. That's adjusted for expenses, sick days etc. It does not cover vacation though and it assumes that I am able to line up new contracts back-to-back, which may not always be the case.
- Communitivity 10y agoAgree 100%. I derived my formula just to match what you would make in a salaried job, and there are other pieces to factor in as well that I left out for simplicity. For it to make sense you need to figure out how much more you want to make for it to be worth it as a career. If you are just starting out as a freelancer though, you might be ok with just matching salaried for your first year clients.
- gtirloni 10y agoThanks for the insights, much appreciated. If you don't mind me asking, what's the W/Y and W/Z ratios in your case? Do you find it useful to charge it per day instead of hourly (if you've done so)?
- brudgers 10y agoTo be clear, I am in the US so travel usually means driving. When I drive I charge time at my usual rate plus mileage at the IRS standard rate. I don't discount my rate based on task though sometimes it is helpful to have a flat rate to visit the client because it allows business over lunch or dinner without straining client relations. In terms of retainer, the retainer at a minimum reflects the maximum amount of work I expect might happen between my invoices on a small project. On a larger project, it will cover several invoices. The intent of applying the retainer against final invoice is that I always owe work for what I have been paid rather than the client owing me money for work I have already done. If there is an unpaid invoice, I stop work without being in the hole, and my contract says that will happen. The potential downside is owing work that won't produce a check (because it already has). On a larger contract, I may apply part of the retainer to invoices in the latter portion of the project so I am not holding onto as much of the client's money when there is a better basis for trust and the project is looking successful. This better aligns cashflow with work remaining which makes client's happier and removes some psychological overhead from my work. Early in my freelancing I would spend a lot of time preparing proposals. I typically charge by the hour because it is straight forward in an early conversation. Coming up with a price quickly is valuable because it qualifies prospects and I can walk away from a meeting with a check. The sooner it clears the sooner I start. Days match up better with some projects than others. At one time I usually proposed in half days, and that was working for the kind of projects I was doing...most of the tasks were about a half day and near the beach it the business climate was more casual.
- zerr 10y agoCan you share more details about how you handle/charge for retainers?