4 ms·
I'm really pleased that there are people doing this kind of stuff. It's awesome to see. > The pins were manufactured by AMP, which was still in business. They
by DanBC 10y ago
I'm really pleased that there are people doing this kind of stuff. It's awesome to see.
> The pins were manufactured by AMP, which was still in business. They had taper pins in gold or tin, but not in the silver that was required for the CDC 6500. With a bit of convincing, negotiating, and LCM+L’s promise to purchase 50,000 pins, AMP agreed to produce a limited run of silver pins:
Can anyone say why silver pins are needed?
Silver seems to me to be the worst material for a connector.
- dom0 10y agoSilver-plated contacts are fairly widespread in use, e.g. better XLR connectors, some Fastons, Hartings etc. use them. They are unproblematic with contact designs that scrape the natural oxide layer off. Mixing platings may prevent this mechanism from working properly, resulting in bad contact.
- simcop2387 10y agoYea I think because of the softness you couldn't switch to gold only partially or it'd wear exceedingly fast. It sure about other metals though.
- jandrese 10y agoMixing metals can also lead to corrosion. Luckily this seems to be a "spare no expense" rebuild.
- jacquesm 10y ago> Can anyone say why silver pins are needed? > Silver seems to me to be the worst material for a connector. It's pretty good actually. Low resistance, very good skin effect. That's why it's usually silver over copper, all of the advantages and not nearly the same price. Most quality RF components and connectors are silver plated.
- VLM 10y agoThe oxide is conductive. The gold to silver price ratio used to be ridiculous compared to historical levels probably due to the death of film but its always been the cheap alternative.