4 ms·
Out of curiosity, why did you ballpark the length of the wire to "2 feet" (close to an order of magnitude high, way under 1 digit of precision) but specify the
by ajross 10y ago
Out of curiosity, why did you ballpark the length of the wire to "2 feet" (close to an order of magnitude high, way under 1 digit of precision) but specify the wave propagation speed along that wire to one part in a thousand (way more precision than appropriate: line capacitance changes significantly with trace width, pcb thickness to ground plane, pcb composition, etc...)?
You're point isn't invalid but it's sort of misapplied. In fact the latency of DRAM on modern systems is dominated almost entirely by precharge time within the memory IC, which is about an order of magnitude slower than signal propagation. And it's not changing, either. DRAM cycles have been sitting at around 60 MHz for a decade and a half. We're dropping voltage as we shrink the cells, and so there's no net increase. Realistically signal propagation will never be the limit.
- Retric 10y agoI very much rounded the output to represent minimal accuracy and while 9.51 e-1 is not accurate to 3 digits 1 digits of accuracy * 1 digits of accuracy = less than 1 digits of accuracy. Anyway, if you actually trace the furthest bit of a ram chip to the CPU it's a longer path than you might think > 1 foot but < 3 feet. As to my point tCL is a round trip latency and actually not that far from optimal. DDR is not designed for pure random access so much as cheap access to lot's of ram so yes there are many trade offs, but they are more reasonable when your close to hard limits.
- gatsby99 10y agoBest practice is to have traces less than 3"
- Retric 10y agoTraces only go from CPU pin to Module, latency includes from memory controller CPU pin, CPU pin to PCB, PCB to module, module to RAM chip edge, ram chip edge to actual memory location. Here is a picture, from the center of the CPU, to the bottom edge of the furthest part of the DIM then up. http://harddiskdirect.com/media/catalog/product/cache/1/image/400x/040ec09b1e35df139433887a97daa66f/2/7/27336450.png_noimage_logo http://harddiskdirect.com/media/catalog/product/cache/1/imag... PS: A DIMM is just over 5 inches wide and 0.7 inches tall so if was centered physically on top of a CPU that's 3 inches right there.
- gatsby99 10y agoYou don't know what you are talking about. Memory controllers are typically onchip.
- Retric 10y agoIf by on chip you mean on CPU I agree: https://en.wikipedia.org/wiki/Memory_controller https://en.wikipedia.org/wiki/Memory_controller But, that's part of the CPU packaging, a signal needs to get to these pins on the bottom of the CPU and that takes time.
- koverstreet 10y ago"You don't know what you are talking about" is not a great response to someone who's writing more substantive posts than you.