3 ms·
This is fantastic, very useful stuff. I literally just finished writing a similar post: https://www.stavros.io/posts/making-gsm-board/ https://www.stavros.io/p
by StavrosK 10y ago
This is fantastic, very useful stuff. I literally just finished writing a similar post:
https://www.stavros.io/posts/making-gsm-board/ https://www.stavros.io/posts/making-gsm-board/
Conor, can you detail how the assembly is done a bit? I've made a few boards with KiCAD but I have no idea how to go from bare PCB to assembled PCB, especially for such low cost as yours.
I went to PCBcart but counting all the items on my board was a hassle, and I got a cost of $38 per board for a run of ten, which sounds too expensive. Besides that, how do you even export the BOM from KiCAD? It doesn't come with a plugin by default.
A few details or a post on how to go from PCB design to assembled board would be very useful, at least to me.
- conorpp 10y agoThank you! Assembly depends on the service you end up using. For PCBCart, I think I just ended up filling out their template BOM manually. Not much of a hassle since I only have 8 parts. I just had to match the component references on the PCB to the BOM, count the number of pins, provide part number, etc. They figured everything else out, just a question or two on part polarities. Yeah getting boards assembled for small volumes will likely not be cost effective. You can mess around with online quote tools to get an ideal if it'd be worth it or not. Using parts with pins that extend out from the package (rather than underneath) will always be more cost effective. Less pins is cheaper too.
- StavrosK 10y agoAh, thanks for the info!