2 ms·
> Wear on roads is to the fourth power of pressure. The rule of thumb in civil engineering is actually fourth power of axle load, per axle. > So the pressure
by masklinn 10y ago
> Wear on roads is to the fourth power of pressure.
The rule of thumb in civil engineering is actually fourth power of axle load, per axle.
> So the pressure might be 3x and thus the wear 3 x 3 x 3 x 3 = 81 times as much.
Considering the rule of thumb is by axle load (not pressure density) you're off by about two orders of magnitude when comparing a large sedan to an 18-wheeler:
* A Model S is 2T over 2 axles, or 2 * 1T/axle
* A fully loaded 18-wheeler can go up to 36T (legal limit) over 5 axles, or 5 * 7.2T/axle[0]
That means the road wear per mile of an 18-wheeler is up to 2.5 (number of axles) * 7.2 (axle load) ^ 4 (4th power), or 6700 times the road wear of a Model S.
Now that's a worst case scenario (unloaded model s versus fully loaded 18-wheeler), but you get the point.
[0] on average, the front axle is usually ~5.5T with the rear axles being in the 7.5~8T range which increases the road wear difference quite a bit, to about 7500